Was going to run a new Romex cable to a laundry light switch so it has a neutral. Was not expecting the guy to have actually used wall clips when he finished the basement.
Glad I ran my new endoscope through the wall before I started trying to pull new wires.
I could just cut a hole in the drywall and patch it, but frankly, I don’t want to go through that effort. I also don’t have one of those extended bits that let you bore a new hole in the studs. Oh well.
I did, however, replace the shitty old light in the nursery with a fancy new Hue ceiling light. Makes the room look even better in terms of finish and probably doubled the total brightness in the room. Getting so close!
edit: needed a neutral because I wanted to install a smart switch that turns on with motion. Helpful when carrying full loads into a dark laundry room. I know I could use a “no neutral smart switch” but I don’t like how they operate. “Off” is basically extremely low, but not zero, amps so the lights appear as though they’re off. I’m sure this is perfectly fine but something doesn’t sit right with me about it.